 |
| Ingredients for first extract recipe |
After brewing with kits and experiments I finally moved up the ladder to extract brewing. I purchased a small 4 gallon stock pot and finally got round to using BeerSmith to its potential! My first brew was initially meant to be a Dogfish Head 60 Minute IPA clone based on
this recipe but none of the Irish home brew stores had all the hops so I had to substitute. I think most hops were substituted quite well other than the Amarillo Hops which seem to be quite unique. I also had to get a slightly different type of grain (Crystal 60L) for the same reason as the hops. I'm thinking that with the amount of substitutions it is no longer a clone. :)
 |
| Steeping the grains, Crystal |
Initially I brought the water up to 65 degrees and put
in the grains to steep for around 20 minutes. As my stove is so slow to heat the water, I was able to turn it down to the lowest output and that kept the temperature relatively constant. The colour change from a couple of minutes of steeping the grains can be seen in the adjacent image.
After steeping, I removed the grains and didn't sparge them although I have read in several places that you should, so I might do that the next time. I then brought the water to a boil which took AGES due to the poor cooker. The length of time that it takes to bring it to a rolling boil really made me understand while all the yanks are using propane burners or huge elements in their kettles. It really is a time saver to have a decent source of heat.
Once boiling, the endurance test began. The recipe calls for the wort to be continuously hopped for the full 60 minutes. I had two timers going, one for the total 60 minutes and the other which went off every minute to signal a hop addition. The idea behind this is to add a few pellets/cones every minute so that you end up spreading out the whole lot over 60 minutes. I was extremely paranoid about a boil-over so I had 2 tea towels ready to grab the handles and take it off the head at the first signs of boiling over. Thankfully the boil-over never really happened, probably due to the length of time it takes for the cooker to bring the wort to the boil.
Once the 60 minutes had elapsed, I took the pot off the head and lowered the pot into a sink of cold water. I then ran down to my local store and got 2 bags of ice which I then dumped into the pot. The ice is surprisingly effective at getting the wort down to pitching temperatures. I have seen arguments about putting ice about whether it is a good idea or not but it is safe to assume that the ice is completely sterile as otherwise people would be getting sick when consuming it with their drinks.
 |
| High Krausen! |
It took about 5 minutes for the wort to cool once the ice was added so I then transferred it to a freshly sanitised fermenter through a couple of sieves. There was a lot of debris in the wort due to the large amount of pellet and whole hops so the sieves got clogged repeatedly. I topped up the fermenter to the 19L mark with cold tap water and pitched the yeast. I had previously made a 1L starter with a sachet of Safale US-05 and some malt extract. Due to my experience of using kits I wasn't familiar with the necessity of using a blow-off tube.....It was necessary this time.....for several days in fact! Part of the problem was due to the fact that the capacity of the fermenter was only 23L (as opposed to the normal 30L) so the head-space was quickly filled with Krausen. It is due to reactions like this that I have added this brewing t shirt to my Christmas list. :)
